ceramic tile repairs floor tile replacment and shower regrouts

Tile repairs are a very specialized service and its hard to get tile contractors interested in small sometimes difficult detailed repairs.The trick to these repairs are to remove and replace the cracked or broken materials without it being obvious its been repaired.To complete these repairs and it not look like a after thought is  a very
tricky undertaking.The first step is to remove the grout around the targeted tile so as not to disturb the tiles around it that will not be removed.Grout binds together tiles and gives it solidity and if not removed then action against one tile can effect others if the grout is not removed first.Alot of times it takes a hammer and a chisel to remove tiles and if the grout is not removed first then the impact can break surrounding tiles around the tile being removed.
   After the grout is removed  then the tile to be replaced can be broken from the middle out in pieces and removed carefully using the hammer and chisel a little at a time or all at once if the tile is not bonded very well. If it is bonded strongly  then a little at a time is the only way to remove it.After the tile is removed  then the task of chipping of the thin set or adhesive is the next step and can be very difficult and time consuming as well as very messy and create alot of dust.Again the hammer and chisel will be your best bet unless you have a electric alternative such as a way to sand or chip away at the concrete left stuck under the tile on the wall or floor.Once you've removed all the adhesive,you can re adhere your replacement tile back in place of the one you've removed, wait some time for it to dry and then re grout the repaired area with the same color grout as the rest of the area around the repair.
   Shower re grouts are in some ways much easier because you don't have to worry about breaking tiles from removal. But scraping and cleaning of the grout and old caulk can be very patients testing. Any loose grout or caulk has to be removed completely before  the new can be applied.The trick to these repairs is getting the new grout to adhere to the old grout.This is generally accomplished by removing enough grout from the area so the new grout has room to stay.Generally you need a 1/8 of a inch of new grout on top of old for it to adhere and not flake out later.Repairs are in some ways much harder than standard installations and in many cases you should get a professional to come out and implement the repair if possible.If you cant seem to gather any interest from any tile guys to do your repair  I will be glad to assist you in any way I can  just give me a call and Ill gladly walk you  through it right over the phone Chris Lawson owner operator tile excellence inc   978-471-9127